Profile Info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Noob 2103

Pages: [1]
1
Open Source Hardware / Brushless ESC latest schematic
« on: July 24, 2020, 04:04:16 AM »
Sir i want your brushless esc latest schematic
I'm from India our custum service are not good
So don't want hardware I  can assamble it
That's why I want
Only schematic I can pay for it but I need it urgently because I have to use it in my drones
Please help

2
Motors, Mechanics, and Power / ESC design
« on: June 01, 2020, 05:54:52 PM »
sir can i use your designed ESC in my drone or any further modifications needed...?

3
Motors, Mechanics, and Power / Re: ESC Prototype
« on: June 01, 2020, 05:53:22 PM »
sir can i use your designed ESC in my drone or any further modifications needed...?

4
Programming Questions / esc programming 1
« on: May 06, 2020, 07:08:25 PM »
sir
in the part of code in photo
 please explain in image what is  set_PWM() function i know that we loading the output compair register of timers
that is
OCR1A  = width_value;                   // Set pin 9  PWM duty cycle
  OCR1B  = width_value;                   // Set pin 10 PWM duty cycle
  OCR2A  = width_value;                   // Set pin 11 PWM duty cycle
but why we are loading these registors

5
Programming Questions / Re: esc programming
« on: May 06, 2020, 09:17:46 AM »
thank you so much sir your just grate
it is the most confusing code i ever seen

6
Programming Questions / esc programming
« on: May 05, 2020, 08:43:26 PM »
sir
in the part of code in photo
what is the function of that while(i>500) loop

7
Installation & Troubleshooting / ESC code
« on: May 05, 2020, 12:48:30 PM »
sir in this part of ESC code
in "for loop" we are increasing the "i" and again in "if"statement we decrease the "i" then when this   "set_next_step();" function will execute
or when we come out from "for loop"
please reply it is very important for me

Pages: [1]